Skip to main content
Version: 1.0.0

5.1 Device pair modify

Each set of Power Debugger devices has been paired before delivery and can be used out of the box in local WIFI direct connection mode. In LAN or public network mode, there may be a complete set of Power Debugger devices (two sets of complete devices, two transmitter terminals and two receiver terminals) on the development end and target board. At this time, if it is necessary to connect the development end transmitter to the receiving end of the target board, the pairing of the device needs to be modified. The specific operation process is as follows.

5.1.1 Transmitter pairing adjustment​

  • Connect the transmitting device (Do not connect the receiving device)
  • Switch to the hardware Settings page and adjust the MAC address of the required pairing receiver on the device Pairing function page (Manually enter)
  • Update pairing

image-20230906100453613

5.1.2 Receiver pairing adjustment​

  • Connect the receiving device (do not connect the transmitting device)
  • Switch to the hardware Settings page and adjust the transmitter MAC address you want to pair on the Device Pairing function page (Manually enter )
  • Update pairing

image-20230906100646059

5.1.3 How do I view the MAC information of my device​

Connect the corresponding device, you can view the corresponding MAC address information on the About page, as shown below.

image-20230906100732686